 |
 |
 |
|
|
|
AGILENT |
|
|
|
 |
AGL N4256A, Amplifier Distortion Test Set. 500 MHz to 4 GHz. Uses cancellation technique to reduce distortion from source to boost dynamic range of existing spectrum analyzer
|
$950 |
$2000 |
|
|
AUDIO PRECISION |
|
|
|
|
AUD ATS-1/ATS-1MD, Audio Test System. 12 measurements. Similar to Portable One models. With IEEE
|
$ Call |
|
|
|
BOONTON |
|
|
|
|
BTN 8200, Modulation Analyzer, 100 kHz to 2.5 GHz, Measures AM/FM/Phase Mod., Freq., Level, Audio Freq. & Distortion/Sinad, w/GPIB & Internal AM/FM/Phase Mod. Calibration Std's
|
$ Call |
$7995 |
|
|
BTN 8210, FM/AM Modulation Meter & Analyzer, 2 MHz to 1.5 GHz, Digital Readout, Automatic Tuning & Leveling, SPECIAL!!
|
$ Call |
$1990 |
|
|
BTN 82AD/1A, Modulation Meter, 10 MHz to 1.3 GHz, Accuracy 2% for AM/FM, IEEE
|
$450 |
$4695 |
|
|
DATA PRECISION |
|
|
|
|
DPN 6000, Waveform Analyzer, Multifunction Analyzer includes O'scope/Spectrum Analyzer, Processor, Data Logger, etc., to 100 MHz, Mainframe only!
|
$750 |
$8995 |
|
|
DPN 611, plug-in for 6000, 100 kHz, 4 Channels
|
$650 |
$3495 |
|
|
DPN 620, plug-in for 6000, 100 MHz, 2 Channels
|
$995 |
$6895 |
|
|
DPN 640, plug-in for 6000, 1 GHz, 4 Channels
|
$750 |
$6995 |
|
|
EATON CORPORATION |
|
|
|
|
|
|
|
|
|
EAT 2075, Noise Gain Analyzer, 10 MHz to 1.8 GHz, Programmable, Digital Displays
|
$1750 |
|
|
|
EAT 7618E, Noise Generator, 1-18 GHz, BNC(f) input, SMA(f) output connector
|
$595 |
|
|
|
ELECTRO-METRICS |
|
|
|
|
ELM CPR-25, Interference Analyzer, 10 kHz to 1 GHz, comes with CIG-25 Impulse Generator & ESC125C Programmer
|
$1750 |
|
|
|
ELM EMC-30 MK IV, EMI Analyzer. 9 kHz to 1000 MHz. Tests to MIL-STD-461/462, SAE ARP 1972, FCC/VDE/CISPR standards. Microprocessor controlled. Variable sweep scan/dispersion
|
$ Call |
|
|
|
FAIRCHILD |
|
|
|
|
FAI EMC 10, Interference Analyzer, 20 Hz to 50 kHz
|
$1250 |
|
|
|
FAI EMC 25, Interference Analyzer, 14 kHz to 1000 MHz
|
$1450 |
|
|
|
HEWLETT PACKARD |
|
|
|
|
HPC 11722A, Sensor Module, 100 kHz to 2.6 GHz, for use with 8902A
|
$1450 |
$3040 |
|
|
HPC 11793A/001/C16/H16, Microwave Downconverter. To 26 GHz. External Signal Generator required with +8 dBm leveled output. For use with 8902A
|
$9500 |
|
|
|
HPC 339A, Distortion Analyzer, .0018% THD, 20 Hz to 110 kHz
|
$950 |
$4875 |
|
|
HPC 346A, Noise Source, 10 MHz to 18 GHz, 5-7 dB ENR
|
$ Call |
|
|
|
|
|
|
|
|
HPC 346B, Noise Source for use w/8970 Noise Figure Meter, 10 MHz to 18 GHz
|
$1350 |
$1770 |
|
|
HPC 346B/002, Option 002 is APC-7 Connector
|
$1350 |
|
|
|
HPC 346B/4, Noise Source for use w/ 8970 Noise Figure Meter, 10 Mz to 18 GHz, Opt. 004 adds Type-N female connector
|
$1400 |
|
|
|
HPC 346B/H01, Same as 346B with ENR instead of normal 15.2 dB
|
$ Call |
|
|
|
HPC 346C, Noise Source, 10 MHz to 26.5 GHz, APC-3.5 male connector 12-16 dB(10 MHz-12 GHz) & 14-17 dB (12-26.5 GHz)
|
$ Call |
$2365 |
|
|
HPC 346C/K01, Broadband Noise Source, 1 to 50 GHz, ENR limits 20 dB at 1 GHz and 7 dB at 50 GHz)
|
$ Call |
$3715 |
|
|
HPC 8901A, Modulation Analyzer, 150 kHz to 1300 MHz, Progr.
|
$400 |
$13265 |
|
|
HPC 8901B/001, Modulation Analyzer, 150 kHz to 1300 MHz
|
$700 |
$18245 |
|
|
HPC 8902A/2, Measuring Receiver, 150 kHz to 1300 MHz, Measures RF Power, RF Level, carrier noise/adjacent channel power, modulation & RF Frequency, characterizes audio signals. Opt 2 adds High Stability Timebase
|
$ Call |
|
|
|
HPC 8902A/4, Measuring Receiver, 150 kHz to 1300 MHz, Meas. RF Power, RF Level, carrier noise/adjac. chan. power, modul. & RF Freq., characterizes aud. signals, Opt 4 adds oper. from 48 Hz to 400 Hz power line
|
$ call |
|
|
|
|
|
|
|
|
HPC 8903A, Audio Analyzer, 20 Hz to 100 kHz, Fully Programmable, opt. 001: Rear Panel Connections
|
$695 |
$6620 |
|
|
HPC 8903B/001, Audio Analyzer, 20 Hz to 100 kHz, 0-100 dB, 0.3% Frequency Accuracy
|
$950 |
$8025 |
|
|
HPC 8903E/001, Distortion Analyzer. 20 Hz to 100 kHz
|
$850 |
$5725 |
|
|
HPC 8970A, Noise Figure meter, Noise Measuring from 10 MHz to 1500 MHz, HPIB Programmability
|
$950 |
$10600 |
|
|
HPC 8970B, Noise Figure Meter, 10 MHz to 1600 MHz. Newer version of 8970A
|
$3300 |
$15550 |
|
|
HPC 8970B/20, Automatic Noise Figure Meter, 10 MHz to 2047 MHz (w/opt. 20), freq. res.1 MHz, 0-30 dB meas., -20 to +40 dBm gain, 2nd stage correction, noise fig/gain, 200+ functions front panel, HPIB.
|
$3750 |
$16840 |
|
|
TEKTRONIX |
|
|
|
|
TEK DA4084, Complete w/TM5003 Power Supply, Distortion Analyzer, Programmable, Improved Version of AA5001, w/SINAD instead of IMD
|
$750 |
|
|
located to left of the item and click on it to see the image. 